#Itwinkle wifi app download how to

You may have to give it a few whacks with a hammer to get the plastic fill to give up it’s hold on both pieces of the enclosure. I used a small flat head screwdriver, as I don’t have triangle bits. The board is built, so now it’s time to replace the factory board in the GECE blob. On the capacitor, the pin on the side that has a white strip painted on it needs to go though this hole. On the PCB, there is a small minus (-) sign above one hole. It DOES matter which way this one goes in. Then solder on the 6 pin connector making sure it ends up flat against the PCB. Pay attention to how much heat you use on the pins, as if too much is used, it may melt the solder holding the pins to the ESP board. Fit it into the PCB and try your best to keep it level. We are going to solder the ESP chip directly to the carrier board. You will have to carefully bend the pins so after it’s inserted, it lies flat back against the PCB with the metal tab on the bottom. Make sure when you install the FET it matches the PCB. You will notice it has a semi-circle shape with one flat side. The push button can fit on the board one of two ways. It does not matter which way the resistor goes. Note the direction of the black line on the diode! It must match the white line printed on the circuit board. Next we will add the diode and the 2 resistors. Let’s start by making sure we have all the parts ready. You can download the source files for the PCB with parts list here and the firmware is available here.

#Itwinkle wifi app download how to

This guide will take you through assembly with the assumption you know how to solder parts to a circuit board. The firmware includes a web server that allows the end user to adjust the various settings. Based off the ESP8266 chipset, this design will replace the original controller on the strand and turn the string into a full fledged e1.31 sACN device. This is a build guide for ESPixel GECE a WiFi pixel controller for General Electric Color Effects (GECE) pixels. ESPixel GECE WiFi Pixel Controller Posted in Projects by Bill